262.723.3345 kim@hudapack.com

Stress relieving a part strategically throughout the rough machining can greatly minimize part distortion after the final heat treating.

All stresses induced during the manufacturing of the part will be relieved during heat treating. Because of this relieved stress please.

The atmosphere must be conditioned and the carbon potential setpoint is the carbon content of the material’s chemical composition.

Setting the carbon potential accurately is important.

  • Too low of a setpoint and decarburization of the part surface will occur.
    • If this occurs a carbon restoration cycle must be run to “correct” the surface carbon content.
  • Too high of a setpoint will cause carburization of the part surface.
    • Under this scenario the engineering group must analyze the hardness and mechanical properties of any mating part before accepting this carburized condition.

Heating the material above the ACӡ temperature and staying above this temperature for the assigned time period is critical to form 100% austenite then rapidly cool the component to transform the microstructure to 100% martensite.

  • There are alloy materials that do not 100% transform to 100% martensite. Meaning there is austenite that did not transform.
    • This microstructure is called having “retained austenite”.
      • Cryo treatment does help transform this remaining austenite however customer approval by their engineering group must be had.
    • The “retained austenite” can be viewed under microscopic evaluation.